Configuring A New Device; Wizard - Quick Start Via Pdm - Siemens SITRANS FC430 Operating Instructions Manual

Commissioning
6.4 Commissioning with PDM
6.4.5

Configuring a new device

Note
Clicking on "Cancel" during an upload from device to SIMATIC PDM will result in some
parameters NOT being updated.
1. Check that you have the most recent EDD, and if necessary update it, see "Updating the
Electronic Device Description (EDD)" in Initial setup (Page 89).
2. Launch "SIMATIC PDM – Manager Device Catalog", browse to the unzipped EDD file and
select it.
3. Launch SIMATIC Manager and create a new project for the device.
4. After the reset is complete upload parameters to the PC/PG.
5. Configure the device via the Wizard Quick Start.
6.4.6

Wizard - Quick Start via PDM

The graphic Quick Start Wizard provides an easy 7-step procedure that configures the
device for a simple application.
Please consult the SIMATIC PDM operating instructions or online help for details on using
SIMATIC PDM.
Quick start
Note
• The Quick Start wizard settings are inter-related and changes apply only after you click
on "Apply and Transfer" at the end of step 7 to save settings offline and transfer them to
the device.
• Do not use the Quick Start Wizard to modify individual parameters.
• Click on "Back" to return and revise settings or "Cancel" to exit the Quick Start.
Launch SIMATIC PDM, open the menu "Device – Wizard - Quick Start", and follow steps 1 to 7.
92
Operating Instructions, 05/2015, A5E03361511-AF
FC430 with HART