Installing/Mounting; Safety Notes - Siemens LDS 6 Compact Operating Instructions

Installing/mounting

3.1

Safety notes

Note
Material compatibility
Siemens can provide you with support concerning selection of parts wetted by process media.
However, you are responsible for the selection of parts. Siemens accepts no liability for faults or
failures resulting from incompatible materials.
NOTICE
Use in a domestic environment
This Class A Group 1 equipment is intended for use in industrial areas.
In a domestic environment this device may cause radio interference.
Incorrect mounting at Zone 0
Risk of explosion in hazardous areas.
• Ensure sufficient tightness at the process connection.
• Observe the standard IEC/EN 60079-14.
Exceeded maximum permissible operating pressure
Risk of injury or poisoning.
The maximum permissible operating pressure depends on the device version, pressure limit
and temperature rating. The device can be damaged if the operating pressure is exceeded. Hot,
toxic and corrosive process media could be released.
Ensure that maximum permissible operating pressure of the device is not exceeded. Refer to
the information on the nameplate and/or in Technical data (Page 59).
LDS 6 & Optics housing CD 6 Compact Operating Instructions
Compact Operating Instructions, 12/2022, A5E03314905-AB
WARNING
WARNING
3
21