Agilent Technologies 5975C TAD VL MSD Troubleshooting And Maintenance Manual page 43

Foreline pressure is too low
If the pressures you observe are below 20 mTorr, check for the following:
• Column (carrier gas) flow is too low
• Column plugged or crushed by an overtightened nut
• Empty or insufficient carrier gas supply*
• Bent or pinched carrier gas tubing*
• Foreline gauge is not working correctly
Analyzer chamber pressure is too low
If the pressures you observe are below 1 × 10
• Column (carrier gas) flow is too low
• Column plugged or crushed by overtightened nut
• Empty or insufficient carrier gas supply*
• Bent or pinched carrier gas tubing*
Gauge controller displays 9.9+9 and then goes blank
This indicates the pressure in the analyzer chamber is above 8 × 10
• Solvent peak from an on-column injection
• MSD has not had enough time to pump down
• Excessive foreline pressure
• Vacuum gauge has failed
• Line voltage too low
• Turbo pump is not working correctly
• Diffusion pump fluid level is low or fluid is contaminated
5975 Series MSD Troubleshooting and Maintenance Manual
* These could create a fault condition in the GC that would prevent the GC
from operating.
* These could create a fault condition in the GC that would prevent the GC
from operating.
General Troubleshooting
-6
Torr, check for the following:
2
-3
Torr.
43