3
CI Troubleshooting
Signal-Related Symptoms
This section describes symptoms related to the signal. The symptom may be
too much signal, too little signal, a noisy signal, or an incorrect signal.
Signal-related symptoms are generally observed during tuning but may also be
observed during data acquisition.
Error messages in autotune due to insufficient signal may vary.
The following symptoms are covered in more detail in this section:
• No peaks. See
• No or low reagent gas signal. See
• No or low PFDTD signal. See
• Excessive noise. See
• Low signal-to-noise ratio. See
• Large peak at m/z 19. See
• Peak at m/z 32. See
68
page
69.
page
page
page
74.
page
page
75.
page
76.
5975 Series MSD Troubleshooting and Maintenance Manual
71.
73.
74.