3Com VCX V7000 Installation Manual page 379

Instructions Use the appropriate instructions from this section to replace the disk on
(Single Site, the Primary or Secondary VCX Server and bring the server back into
Two Servers) service.
If this server is configured for RAID operation, see
earlier in this appendix.
1 Replace the failed disk and start the server.
a Remove power from the down server.
b Remove the failed disk.
c Install the replacement disk.
d Reapply power to the server.
e Press the start button on the front panel.
2 After the server has started and the login prompt appears, log in as root
and configure networking parameters on the down server by entering
this command:
vcx-config-network --wizard
If the down server is the primary VCX server, follow the instructions in
Configuring a Primary IP Telephony and Messaging Server
If the down server is the secondary VCX server, follow the instructions in
Configuring a Secondary IP Telephony and Messaging Server
Chapter
3 If necessary, upgrade the software on the down server to match the
software version on the partner server.
a Compare the software version on the down server to the software
b If the down server is running an earlier software version than the
The location of the software upgrade file depends on 3Com's service
delivery methods and on the customer network configuration.
Software upgrade file names vary with the release. See
Software Files
assume that you need to upgrade to VCX Enterprise release 7.1.16c.
2.
version on the running server.
On the running server and on the down server, enter this command:
vcx-showversion
running server, download the appropriate software upgrade file to the
directory on the down server.
/opt/installtemp
earlier in this appendix. The examples in this section
Replacing a Disk (Single Site)
RAID Disk Failure,
in Chapter
Names of
379
2.
in