3Com VCX V7000 Installation Manual page 356

356 C 9: I
HAPTER NSTALLING
D
EVICES
a Open a browser on your PC and enter the IP address of the Media
Gateway portion of the V6000.
b In the page that appears, enter the user name and password. The
defaults are Admin, Admin. If you changed the default values when
you first configured the Media Gateway, enter the new values.
Both user name and password are case sensitive.
c Click Quick Setup and change the Gateway Name to the host part
of the SIP URI for any FXS endpoint. For example, if the SIP URI is
sip:1000@1.1.1.1, enter 1.1.1.1 as the Gateway Name.
VCX systems use the dialing domain as the host part of the SIP URI. 3Com
recommends that customers use 1.1.1.1 as the dialing domain for all VCX
servers.
d Click Reset.
e Click OK.
The Media Gateway restarts. After the restart has been completed,
the newly configured value takes effect.
5 Configure Use Gateway Name for OPTIONS to Yes.
a Open a browser on your PC and enter the IP address of the Media
Gateway portion of the V6000.
b Enter the user name and password (the defaults are Admin, Admin).
Both user name and password are case sensitive.
c Click Protocol Management > Protocol Definition > Proxy &
Registration.
d Scroll down and locate Use Gateway Name for OPTIONS.
e From the dropdown list, select Yes.
f Click Submit.
Configuring VCX Processor
To connect the VCX Processor to your network:
1 Connect an Ethernet cable (RJ-45 connector) to the Ethernet port on the
back panel of the unit.
2 Connect the other end of the Ethernet cable to your network.
3 Connect the serial cable (supplied with the unit) to the serial port that is
located in the lower left corner of the Connection Module on the back
panel.