3Com VCX V7000 Installation Manual page 332

332 C 9: I
HAPTER NSTALLING
D
EVICES
11 Press 1 (Alt Dnld Servr).
12 Enter the IP address of the Alternate Call Processing Server.
13 Press # to save the new setting.
14 Disconnect and reconnect the telephone power cord.
The telephone:
Obtains an IP address from a DHCP in your network.
■
Contacts the Primary Call Processing Server and begins to download
■
the appropriate software.
During the downloading process, several progress messages appear in
the telephone display panel. After the software has been downloaded to
the telephone, the message "Local Phone Number:" appears.
To log in on the telephone, a user enters:
An extension number, followed by #
■
A numeric password, followed by #
■
To assign a telephone extension to a user, you must configure the
telephone extension number and user ID using the VCX Administrator
User Interface. For information about how to perform these tasks, see the
VCX Administration Guide.
Configuring the 3Com 3102 Telephone Without a DHCP Server
If your network does not use a DHCP server to provide IP addresses to
devices, you must manually configure the IP address of the 3Com 3102
Business Telephone.
1 Configure the telephone as described in
with a DHCP Server
2 Press the Program button, located at the top of the row of buttons on
the right side of the telephone.
3 Press 2 (Set My IP).
4 Enter the IP address that you want to assign to the telephone.
5 Press # to save the new setting.
6 Press 3 (Set SubNMsk).
7 Enter the subnetwork mask appropriate for the subnetwork to which the
telephone is connected.
earlier in this section.
Configuring the 3102 Telephone