3Com VCX V7000 Installation Manual page 216

216 C 4: I
HAPTER NSTALLING AN
Sample Network Configuration Script — Branch Office IP Messaging Server (continued)
--------------------- Configuring IP Interface 'eth1' ---------------------
Interface State
------------------------- Configuring DNS Servers -------------------------
Enter DNS servers one at a time.
When done, enter 0.0.0.0 to stop.
Primary DNS Server
Secondary DNS Server
Tertiary DNS Server
----------------------- Configuring DNS Search Path -----------------------
Press Enter to leave the current path unchanged, or specify
a new search path, with spaces separating each entry.
DNS Search Path :
-------------------- Configuring Network Time Protocol --------------------
Enter NTP servers one at a time.
When done, enter 0.0.0.0 to stop.
Primary NTP Server
Secondary NTP Server
Tertiary NTP Server
-------------------------- Configuring Time Zone --------------------------
The system can be set to use Coordinated Universal Time (UTC, sometimes called
Greenwich Mean Time or GMT) or to a local timezone.
timezone.
Will this system use UTC? [no] :
Please select a geographic location from the following list:
IP M S
ESSAGING ERVER
: disabled
A branch office VCX server uses only the eth0 network interface. Press
the Enter or Return key to accept the default answer (disabled).
:
:
:
Enter the IP addresses for up to three Domain Name Service (DNS)
servers. The script interprets a 0.0.0.0 address as the end of the list.
Enter the DNS search path appropriate for the domain for the branch
office.
:
:
:
Enter the IP addresses for up to two Network Time Protocol (NTP) servers.
The script interprets a 0.0.0.0 address as the end of the list.
CAUTION: If VCX systems are not synchronized via NTP, timing-related
problems can occur.
Most systems use a local