Gateway Installation - 3Com VCX V7000 Installation Manual

Gateway
Installation
3Com V7111 Analog
Gateways
ID Values:
Integer. Range = 0-4095
■
Example Commands:
■
vcxSetVLANConfig 1,2
This command enables VLAN operation on the virtual LAN with ID = 2.
vcxSetVlanConfig 0
This command disables VLAN operation.
To verify the current settings use the nbxShowConfig and vcxShowConfig
command.
14 Enter this command to restart the Attendant Console and activate the
configuration changes:
nbxReset
This command copies the contents of the non-volatile memory to the
active network settings for the Attendant Console.
The Attendant Console communicates with the Primary VCX Server. Use
the Administrator Interface to:
Associate the Attendant Console with a particular phone
■
Perform the remaining configuration of the Attendant Console (for
■
example, mapping extensions to Attendant Console buttons)
For instructions on how to perform these tasks, see the VCX
Administration Guide.
V7111 Analog Gateways connect the VCX system in two directions:
FXO versions connect to analog trunk lines from the Public Switched
■
Telephone Network (PSTN).
FXS versions connect to analog telephones or fax machines.
■
There are 4-port and 8-port FXO versions of the V7111.
There are 2-port, 4-port, 8-port, and 24-port FXS versions of the V7111.
In addition, one model of the V7111 has 4 FXO ports and 4 FXS ports.

Gateway Installation

345