3Com VCX V7000 Installation Manual page 100

100 C 2: I
HAPTER NSTALLING AN
Sample Services Configuration Script — Secondary Server (continued)
Login Password
Login Password (confirm)
VCX Authentication & Directory Services can provide support for System
Speed Dials. This feature must be enabled only for a single Site ID, and if
replication is in use, the setting must be the same on the primary and
secondary servers for that Site ID. Note: this setting cannot be changed once
initial setup is complete, so be certain it is set correctly.
Enable System Speed Dial Master? [N]
Do you wish to change any of the Auth & Dir Service parameters? [N] :
------------ Configuring additional parameters for Common Agent ------------
The Trap Destination specifies the IP address to be used as a destination
when this system sends SNMP traps.
Trap Destination
IP T M
ELEPHONY AND ESSAGING
This cworks password is used for authentication when replicating this
server's database on a remote Authentication and Directory server. This
password must be the same as the cworks account password on the
remote server. It is not necessarily the same as the password used to log
in to the local cworks account configured earlier in this script.
At a single site, you should have entered Y for the primary server. You
■
must also answer Y here, for the associated secondary server.
For regional offices that have no branch offices, you must configure
■
the two servers in one of the regional offices as System Speed Dial
Master servers. Answer Y for only one pair of servers in one regional
office.
Press the Enter or Return key to accept the default answer (N). If you
answer Y to this question, the script presents each of the items that you
have entered during the most recent part of the script and allows you to
accept the value or change it.
Enter the IP address of the PC or other system on which you are running
your network management software (for example, EMS).
S
ERVER
: ******
: ******
:
: