3Com VCX V7000 Installation Manual page 199

Ip telephony solution system release 9.0
Hide thumbs Also See for VCX V7000:
Table of Contents

Advertisement

Sample Services Configuration Script — Primary IP Messaging Server (continued)
Write Community String
The Read Community String specifies the community string to be used by a
management station when sending read requests to this system.
Read Community String
Common Agent supports a management station authentication feature.
Answering 'Y' here will allow only a set of pre-identified SNMP management
stations to manage the system. (You will be able to enter IP addresses of
authorized management stations next.
also be configured using EMS or another management station at a later
point.)
Enable management station authentication? [N]
Common Agent supports the SNMP V3 protocol.
management station to use the secure SNMP V3 protocol to manage this VCX system.
(You will be able to configure passwords for pre-configured user names next. These
authentication and privacy passwords should be used from EMS or other management
stations when using SNMP V3.) Note that the SNMPV3 feature cannot be enabled from
EMS or other management stations.
Enable SNMP V3 access [N]
Do you wish to change any of the Common Agent parameters? [N] :
----------------------------------------------------------------------------
CAUTION: Press the Enter or Return key to accept the default answer
(private). 3Com strongly recommends that users change this string for
security reasons.
CAUTION: Press the Enter or Return key to accept the default answer
(public). 3Com strongly recommends that users change this string for
security reasons.
Authorized management stations can
Press the Enter or Return key to accept the default answer (N). To enable
management station authentication, enter Y. The script will then accept
the IP addresses of up to four network management stations.
Press the Enter or Return key to accept the default answer (N). If you
answer Y to this question, the script presents each of the items that you
have entered during the most recent part of the script and allows you to
accept the value or change it.
: private
: public
:
Answering 'Y' here will allow an SNMP
199

Advertisement

Table of Contents
loading

Table of Contents