Amarok 2011 ➤
4-cylinder injection engine (2.0 l direct injection engine, turbocharger) - Edition 02.2011
15 –
Cylinder head, valve gear
1
Cylinder head
1.1
Assembly overview - cylinder head
Note
Renew cylinder head bolts.
♦
During fitting work, renew self-locking nuts, bolts which have
♦
been tightened further as well as oil seals and gaskets.
The plastic protectors fitted to protect the open valves must
♦
only be removed immediately before fitting the cylinder head.
When fitting a new cylinder head or cylinder head gasket, drain
♦
off all the old coolant and refill with new coolant.
1 - Cylinder head gasket
❑ Renew.
❑ Observe installation po‐
sition: Part number to
cylinder head
2 - Bolt
❑ 25 Nm
3 - Transport lug
4 - Bolt
❑ Tighten in 2 stages:
1.
Tighten to 8 Nm
2.
Use fixed wrench to
turn 90° further
5 - Cylinder head
❑ Removing and installing
⇒ page 48
.
❑ Check for distortion
⇒ page 48
.
6 - Cylinder head bolt
❑ Renew.
❑ Note procedure when
loosening
⇒ page 48
❑ Note procedure when
tightening
⇒ page 46
❑ Tighten in 3 stages:
1.
Tighten to 40 Nm
2.
Use fixed wrench to
turn 90° further
3.
Use fixed wrench to
turn 90° further
46
Rep. gr.15 - Cylinder head, valve gear
.
.