4-cylinder injection engine (2.0 l direct injection engine, turbocharger) - Edition 02.2011
– Apply silicone sealant onto clean sealing surface of cylinder
head cover, as illustrated -arrows-.
♦ Thickness of sealant bead: 2 ... 3 mm.
Note
The cylinder head cover must be installed within 5 minutes
♦
after applying the silicone sealant.
The bead of sealant must not be thicker than specified, other‐
♦
wise excess sealant can enter the sump and obstruct the
strainer in the oil intake pipe.
Observe expiry date of sealing compound.
♦
Sealant ⇒ Electronic parts catalogue .
– Fit cylinder head cover onto cylinder head.
– Renew bolts for cylinder head cover.
– Tighten bolts in several stages, tightening sequence
⇒ page 92
.
Note
Take care to keep cylinder head cover level.
– Use thrust piece -T10174- to drive in sealing cap -1- (do not
apply sealant).
- a -: 1 ... 2 mm
– Turn vibration damper to „TDC" position -arrow- using coun‐
terhold -T10355- .
•
Notch on vibration damper must align with arrow marking on
bottom cover for timing chains.
Note
The timing chain links with markings must be positioned at the
markings on the chain sprockets.
Amarok 2011 ➤
103
3. Valve gear