Volkswagen Amarok 2011 Workshop Manual page 18

Amarok 2011 ➤
4-cylinder injection engine (2.0 l direct injection engine, turbocharger) - Edition 02.2011
– Hang up lifting tackle -2024 A- as shown in figure, using hole
1 -arrow A- and hole 7 -arrow B-.
– Unscrew the two upper bolts -1-.
– If necessary, disconnect all connecting, coolant, vacuum and
intake hoses that have to be disconnected from the engine in
order to remove it.
– Carefully pull engine from gearbox in longitudinal direction. Do
not damage needle bearing in the crankshaft whilst doing this.
Caution
♦ Only a few millimetres of space are available between
plenum chamber and radiator/lock carrier for removing
and installing the engine. The engine must therefore be
guided carefully when raising and lowering.
♦ Raise and lower the engine slowly with the assistance of
a second mechanic.
♦ The workshop hoist -VAS 6100- must also be guided care‐
fully when raising and lowering the engine.
– When raising and lowering engine, make sure that neither
vacuum hose -1- nor connection -2- on vacuum pump are
damaged.
– Guide vacuum hose -1-, connection -2- and vacuum pump
past plenum chamber when raising and lowering.
– When raising and lowering engine, make sure that rollers of
belt drive and turbocharger do not damage radiator.
– When raising and lowering engine, pay attention to lines and
hoses to prevent these from being damaged.
12
Rep. gr.10 - Removing and installing engine