Volkswagen Amarok 2011 Workshop Manual page 216

Amarok 2011 ➤
4-cylinder injection engine (2.0 l direct injection engine, turbocharger) - Edition 02.2011
♦ Hose clip pliers -VAS 6340-
Removing
– Pull off connector -3- for air mass meter -G70- .
– Loosen screw-type clip -4- and remove intake hose from air
mass meter -G70- .
– Unscrew bolts -arrows- from air mass meter -G70- and care‐
fully pull air mass meter -G70- -1- out of air filter housing guide.
Installing
To ensure the proper function of the air mass meter -G70- , it is
important to observe the following notes and instructions.
Note
If the air filter element is very dirty or wet, dirt or water could
♦
reach the air mass meter -G70- and affect the air mass value.
This would lead to loss of power, since a smaller injection
quantity is calculated.
Always use genuine part for air filter element.
♦
Use a lubricant (silicon) to amount the air intake hose.
♦
– Check for salt residues, dirt and leaves in air mass meter -G70-
and air intake hose (pure air side).
– Check intake channel for contamination as far as air filter el‐
ement. If contamination is found, remove salt residues, dirt
and leaves from top and bottom part of air filter housing by
rinsing out or using a vacuum cleaner if necessary.
Install in reverse order.
210
Rep. gr.24 - Mixture preparation - injection