Volkswagen Amarok 2011 Workshop Manual page 95

4-cylinder injection engine (2.0 l direct injection engine, turbocharger) - Edition 02.2011
– Insert shell half -T10394/1- from puller -T10394- .
– Insert puller -T10394- and push locking collar in
-direction of arrow-.
– Screw puller -T10055- into puller -T10394- and force out bal‐
ancer shaft.
Installing
Note
Due to the small amount of play between the balancer shaft and
cylinder block, the balancer shaft may need to be installed chilled.
Check whether the balancer shaft can be fitted into the cylinder
block without exerting force. If this is not the case, the balancer
shaft must be chilled before installing.
• Specified torque
⇒ „2.8 Assembly overview - balancer shaft timing chain", page
80 .
– Check installation position of tube for balancer shaft -arrow-.
Lug -arrow- must engage in slot.
– Place new balancer shaft in freezer compartment for 30 mi‐
nutes, if necessary, or spray with commercially available cool‐
ing spray.
– Lubricate balancer shaft bearing with engine oil.
Amarok 2011 ➤
89
2. Chain drive