Phaeton 2003 ➤
6-cylinder injection engine - Edition 02.2014
15 –
Cylinder head, valve gear
1
Cylinder head
Note
To remove cylinder head, engine must be removed
♦
If an exchange cylinder head is installed, all the contact sur‐
♦
faces between the support elements, roller rocker fingers and
the running surfaces of the cam shafts must be oiled before
the cylinder head cover is installed.
The plastic protectors fitted to protect the open valves must be
♦
removed only immediately before the cylinder head is fitted.
When replacing the cylinder head the complete coolant must
♦
be renewed.
Disconnect the batteries before removing the cylinder head.
♦
⇒ Electrical system; Rep. gr. 27 ; Disconnecting and recon‐
necting batteries.
Removing and installing intake manifold
♦
ing and installing cylinder head cover.
Dismantling and assembling intake manifold
♦
Assembly overview
⇒ page 48
Removing and installing camshaft control valves
Removing and installing cylinder head
Checking valve timing
⇒ page 56
Installing timing chains for intermediate shaft drive and camshaft
drive
⇒ page 58
Install camshaft adjuster with timing chain for camshaft drive
⇒ page 64
Checking compression
1.1
Assembly overview
48
Rep. gr.15 - Cylinder head, valve gear
⇒ page 68
⇒ page 52
.
⇒ page 74
.
⇒ page 3
, remov‐
⇒ page 155
.
⇒ page 79
.