Volkswagen Amarok 2011 Workshop Manual page 37

4-cylinder injection engine (2.0 l direct injection engine, turbocharger) - Edition 02.2011
Preparing counterhold tool -VW 558- :
– Tighten hexagon bolt M8x40 -A- with hexagon nut on clutch
counter-hold tool -VW 558- .
Loosening and tightening drive plate:
– Insert counterhold -VW 558- in cylinder block and drive plate
as shown.
Installation position of counterhold: -A- to loosen, -B- to tighten.
Installing drive plate:
– Fit drive plate without washer -A- first.
– Fit used securing bolts -3- and tighten to 30 Nm.
– Check dimension between drive plate and cylinder block at
three points and calculate average.
Note
Measure through hole in drive plate to milled surface of cylinder
block. When measuring intermediate plate, plate thickness has to
be taken into account.
• Specification measured without intermediate plate: 19.5...
21.1 mm
• Specification measured with intermediate plate: 18.8...
20.4 mm
If the specification is not reached, replace all securing bolts and
tighten.
Amarok 2011 ➤
2. Cylinder block (gearbox end)
31