CC 2012 ➤ , Passat 2011 ➤ , Passat Variant 2011 ➤
6-cylinder direct-injection engine (3.6 l engine, 4V) - Edition 06.2019
15 –
Cylinder head, valve gear
1
Cylinder head
⇒ "1.1 Assembly overview - cylinder head", page 58
⇒ "1.2 Removing and installing cylinder head", page 60
⇒ "1.3 Removing and installing cylinder head cover", page 68
⇒ "1.4 Assembly overview - vacuum pump", page 69
⇒ "1.5 Removing and installing vacuum pump", page 70
⇒ "1.6 Checking compression", page 71
1.1
Assembly overview - cylinder head
⇒ Fig. ""Checking cylinder head for distortion"" , page 60
1 - Holder
❑ For fuel hose
2 - 10 Nm
3 - Cap
❑ Renew seal if damaged.
4 - Cylinder head cover
❑ Removing and installing
⇒ page 68
5 - 10 Nm
❑ With spacer sleeve and
seal.
❑ Renew seal if damaged
6 - Gasket for cylinder head
cover
❑ Renew if damaged or
leaking
❑ Observe installation po‐
sition
7 - Lifting eye
❑ With bolted on retaining
plate for knock sensor
connector.
8 - 23 Nm
9 - Intake manifold support
10 - 23 Nm
11 - 10 Nm
12 - 10 Nm
13 - Union
❑ To heat exchanger
14 - Gasket/seal
❑ Renew
❑ Observe installation position
58
Rep. gr.15 - Cylinder head, valve gear