May 2015
Removing the End-Cap Connector
To remove the end-cap connector:
1.
Remove the end-cap
2. Insert the modified dummy plug into the connector.
3. Place the Extracting Wrench over the connector and dummy plug. The wrench will fit into the End
Cap slot.
4. Flip the end-cap assembly over and insert the socket onto the lock nut. Slide the cable wires into
the socket's clearance slot.
5. Attach a ratchet wrench to the socket and remove the lock nut.
Page 74
EAR-Controlled Technology Subject to Restrictions Contained on the Cover Page.
from the housing.
Figure 32.
Modified Dummy Plug
Figure 33.
Extracting Wrench
Figure 34.
Lock Nut Removal Socket
WorkHorse H-ADCP Operation Manual