Hp - Waves Pings Per Wave Record; Hr - Time Between Wave Records; Table 31: Waves Flow Control - Teledyne WORKHORSE Operation Manual

May 2015
Table 31: Waves Flow Control
Command Description
HFxxx22 Use the same settings as the CF command (default)
HFxxx1x Enable Serial Output – Sends the currents and waves data ensemble out the RS-232/422 serial interface.
HFxxx0x Disable Serial Output – No waves ensemble data are sent out the RS-232/422 interface.
HFxxxx1 Enable Data Recorder – Records waves data ensembles on the recorder (if installed).
HFxxxx0 Disable Data Recorder – No waves data ensembles are recorded on the recorder.
The default HF22222 will be displayed as HF00000 when a "HF?" command is run.
HP – Waves Pings per Wave Record
Purpose Set the number of pings per wave record.
Format HPn
Range n = 0 to 8400
Default HP0
Recommended Setting. Set using WavesMon.
Description The command sets the number of pings collected per wave record (or burst). With this
value set to zero, Waves data collection is disabled.
HR – Time Between Wave Records
Purpose Set the maximum interval between the start of each wave record.
HR hh:mm:ss.xx
Format
hh – hours
mm – minutes
ss – seconds
xx – hundredths of seconds
Range 00:00:00.00 – 23:59:59.99
Default HR01:00:00.00
Recommended Setting. Set using WavesMon.
Description This command sets the maximum interval between the start of consecutive wave records.
If the number of pings per record * the time between pings is greater than the time be-
tween wave records, then the previous wave record will complete before starting the next
one.
Page 186
EAR-Controlled Technology Subject to Restrictions Contained on the Cover Page.
WorkHorse H-ADCP Operation Manual