Installing The Spare Board Kit; Figure 29. Pc Board Connectors; Figure 30. Ground Jumper - Teledyne WORKHORSE Operation Manual

May 2015
5. Remove all PCMCIA card(s) from the original set of boards. These PCMCIA cards will be used
again once you install your Spare Boards Set. The Spare Board set does NOT contain a PCMCIA
card(s). The PCMCIA card(s) are located on the bottom of the DSP board. To remove the PCMCIA
card(s) press the button(s) on the side of the PCMCIA card slot. As you press this button the
PCMCIA card will slide out. You will have to pull the card(s) out the rest of the way once the but-
ton is depressed all the way in.
6. Set the original board set to the side for now.

Installing the Spare Board Kit

To install the spare boards kit:
1. With your earth-ground static protection strap on, remove the Spare Board Kit from the anti-
static bag.
2. Using a 3 mm Allen wrench and a 7mm wrench remove the nuts from the bolts that secure the
Spare Boards together. You will be using these bolts to secure the spare set in your system. DO
NOT change the position of any of the bolts. The bolt containing the felt washers and ground
jumper must remain in the same position (see Figure 30).
3. Place the nuts (just removed) on the four bolts of your original set of boards and place them into
the anti-static bag. You will use the new set of bolts included in the Spare Board kit to secure them
to the Transducer assembly.
4. Install all PCMCIA cards removed in
card slots. The PCMCIA card is keyed and will only connect when it has been aligned correctly and
slid all the way in. The PCMCIA card is installed with the label side pointing away from the DSP
board.
Page 70
EAR-Controlled Technology Subject to Restrictions Contained on the Cover Page.
Figure 29. PC Board Connectors
Figure 30. Ground Jumper
Remove the Original Set of Boards
WorkHorse H-ADCP Operation Manual
step 5 into the PCMCIA