Hb - Automatically Chosen Bins For Wave Processing; Hd - Waves Data Out; Hf - Waves Flow Control - Teledyne WORKHORSE Operation Manual

WorkHorse H-ADCP Operation Manual
HB – Automatically Chosen Bins for Wave Processing
Purpose Set the number of automatically chosen bins for doing Directional Wave Spectra.
Format HBn
n = 1 to 20 bins (n = 0 disables auto-bin selection)
Range
Default HB5
Recommended Setting. The default setting for this command is recommended for most applications.
Description Bins are selected consecutively starting below the "contaminated area." If more than
three bins are selected, and there are sufficient bins in the column, a mid column beam
will be selected. If more than four bins are selected, and there are sufficient bins in the
column, the first bin will be selected.
HD – Waves Data Out
Purpose Select the data output in the Waves Packet Structure.
Format HD abc def ghi
Range abc def ghi can be 1 (On) or 0 (Off).
Default HD 111 000 000
Recommended Setting. The default setting for this command is recommended for most applications.
Description This command selects which data will be output in the waves packet data.
a – Velocity
b – Pressure
c – Surface Track
d – Heading, Pitch, and Roll
e-i – Reserved
HF – Waves Flow Control
Purpose Sets various H-ADCP waves data flow-control parameters.
Format HFnnnnn
Range Firmware switches (Res;Res;Res;Ser;Rec) see Table 31
Default HF00000
Recommended Setting. The default setting for this command is recommended for most applications.
Description The HF command is similar to the CF command (see
command is HF22222 (default), it uses the same settings as the CF command. The HF
and CF commands control if the data goes to the recorder and/or to the serial port. This
allows you to output Waves data (packets) independently from the standard water cur-
rent profiles.
EAR-Controlled Technology Subject to Restrictions Contained on the Cover Page.
CF - Flow Control). When the HF
May 2015
Page 185