Replacing The End Cap Connector; Equipment Provided; Customer Supplied Additional Equipment - Teledyne WORKHORSE Operation Manual

WorkHorse H-ADCP Operation Manual

Replacing the End Cap Connector

This section explains how to replace the 7-pin end-cap connector on a H-ADCP or external battery.
Some older H-ADCP end-caps may have the connector brass lock nut glued into place. If this is the
case for your end-cap assembly, TRDI recommends that you purchase a new end cap assembly.

Equipment Provided

The H-ADCP End-Cap Tools Kit (P/N 757K6122-00) includes the following:
•
Socket, lock nut removal
•
Extracting wrench
•
Plug, dummy, modified
The End Cap Replacement Kit P/N 757K6123-00 (200 and 500 meter systems), 757K6125-00 (6000 me-
ter systems), and 757K6149-00 (H-ADCP External Battery case) includes the following:
•
7-pin end-cap connector with cable and 2-014 O-ring
•
Isolation bushing and 2-017 O-ring (metal end-caps only)
•
Connector, header, 8-pin Molex or 2-pin as needed
•
Fuses and fuse holders, wire, shrink tube (External Battery kit only)
•
Nut, brass
•
End-cap O-ring(s)
•
Desiccant
•
Silicon lubricant, 4-pack
•
Loctite® 242
•
Cord, lacing, black

Customer Supplied Additional Equipment

•
Soft pad (ESD Safe) to rest H-ADCP on while dissembling and reassembly
•
Socket wrench handle
•
Torque Wrench (35 Inch/pound / 4 N-M)
•
Multi-Meter
EAR-Controlled Technology Subject to Restrictions Contained on the Cover Page.
May 2015
Page 73