Testing The H-Adcp - Teledyne WORKHORSE Operation Manual

May 2015
[BREAK Wakeup B]
WorkHorse Horizontal Broadband ADCP Version 11.10
Teledyne RD Instruments (c) 1996-2009
All Rights Reserved.
>

Testing the H-ADCP

These tests checks that the H-ADCP is able to communicate with the computer and runs the H-ADCP Pre-
Deployment tests.
>cr1
[Parameters set to FACTORY defaults]
>ck
[Parameters saved as USER defaults]
Page 10
EAR-Controlled Technology Subject to Restrictions Contained on the Cover Page.
WorkHorse H-ADCP Operation Manual
Wakeup
On the File menu, click Break (you can also press the
End key to send a break or press the B button on the
Toolbar).
The wakeup message should appear on the log file
window.
If the H-ADCP does not respond, check the serial port,
cables, AC power, and battery connection (Sentinel
only). If necessary, refer to the Troubleshooting
tion.
If the wakeup message is not readable or visible:
On the File menu, click Properties.
Click the Auto Detect H-ADCP button.
Click OK when the H-ADCP is detected. Try to wake up
the H-ADCP again.
Both BBTalk and the H-ADCP must use the same
Baud rate.
At the ">" prompt in the communication window,
enter CR1 then press the Enter key. This will set the
H-ADCP to the factory default settings.
At the ">" prompt in the communication window,
enter CK then press the Enter key. This will save the
factory default setting as the default power up condi-
tion.
sec-