Dy - Set Svss To Real Mode; Dz - Get Single Scan From Svss - Teledyne WORKHORSE Operation Manual

WorkHorse H-ADCP Operation Manual

DY - Set SVSS to REAL Mode

Purpose Set the SVSS to Real mode.
Format DY
Recommended Setting. Use as needed.
Description This command sends "RE" out on the RS-485 bus. If the SVSS is listening, it will change
its data output mode to REAL. REAL data is in units of m/s and the form XXXX.XX

DZ - Get Single SCAN from SVSS

Purpose This command gets a single scan of data from the SVSS.
Format DZ
Recommended Setting. Use as needed.
Description This command sends "s" out on the RS-485 bus. If the SVSS is listening, it will respond (-
23ms later) with one scan of data. The data format will be determined by the last format
command ("DX" or "DY") sent to the SVSS. The data will be echoed back by the H-ADCP.
EAR-Controlled Technology Subject to Restrictions Contained on the Cover Page.
May 2015
Page 183