Pc Card Recorder; Figure 26. Pc Card Recorder - Teledyne WORKHORSE Operation Manual

May 2015

PC Card Recorder

The PC Card recorder is located on the Digital Signal Processor (DSP) board inside the H-ADCP's elec-
tronics (see Figure 26). To recover data, the card can be removed and used in a personal computer (PC),
or left in the H-ADCP, and accessed by using BBTalk or WinSC (see the RDI Tools and WinSC User's
Guide).
By default, the H-ADCP does not come with PCMCIA cards. Two PCMCIA memory cards slots are
available, with the total memory capacity not to exceed 2GB.
To remove or install a PC card:
1. Turn off power to the H-ADCP.
2. Remove the transducer head (see
3. Remove the PC cards by pushing the button on the side of the PCMCIA card slot. The card should
"pop" out of the connector. If you cannot reach the release button with your finger, use a plastic
pen or non-conductive tool to depress the button. Do not try to force the card in or out of the con-
nector. PC cards slide easily in or out when properly oriented.
4. When you are finished recovering the data, install the PC card back into the DSP board. PC cards
install with the label side toward the face of the transducer.
5. Install the transducer head (see
Do not use a PCMCIA adapter for compact flash cards. These do not work.
Do not delete files from the PC card using Windows®. This may leave hidden files on the card.
Always use the H-ADCP's
Page 66
EAR-Controlled Technology Subject to Restrictions Contained on the Cover Page.
Housing Assembly
Figure 26. PC Card Recorder
Housing Assembly Replacement).
RE erase command to delete data from the PC card recorder.
WorkHorse H-ADCP Operation Manual
Removal).