Pt - Built-In Tests; Pt Test Results Error Codes; Pt0 - Help; Table 24: Error Code Hex To Binary Conversion - Teledyne WORKHORSE Operation Manual

WorkHorse H-ADCP Operation Manual
>
The error velocity for an H-ADCP is equal to the difference between the Y velocities of beams one and two
and the Y velocity of beam three (Error = V1*E1 + V2*E2 + V3*E3).

PT - Built-In Tests

Purpose Sends/displays results of H-ADCP system diagnostic test.
Format PTnnn
nnn = 0 to 200 (PT0 = Help menu)
Range
Recommended Setting. Use as needed.
Description These diagnostic tests check the major H-ADCP modules and signal paths. Most of the
tests give their final results in the format;
xxxxxxxxxx TEST RESULTS = $hhhh ... rrrr
Where
xxxxxxxxxx = Module or path being tested
$hhhh = Hexadecimal result code ($0 = PASS; see individual tests for description of bit results)
rrrr = Overall test result ("PASS" or "FAIL")

PT Test Results Error Codes

To find what bits are set when an error occurs, use the following tables.
Table 24: Error Code Hex to Binary Conversion
Hex Digit Binary Hex Digit
0 0000 8
1 0001 9
2 0010 A
3 0011 B
4 0100 C
5 0101 D
6 0110 E
7 0111 F
To convert error code $32CF (note: the dollar sign "$" signifies hexi-decimal), convert 32CF to binary.
Error code $32CF has the following bits set: 13, 12, 9, 7, 6, 3, 2, 1, 0.
Hex Digit $
Binary 0 0
Bit # 15 14

PT0 - Help

Displays the test menu (shown below). As implied by the NOTE, adding 100 to the test number repeats
the test continually until the H-ADCP receives a <BREAK>. Sending PT200 runs all tests. PT300 runs all
tests continually until the H-ADCP receives a <BREAK>.
>PT0
Built In Tests
----------------
PT0 = Help
PT1 = NA
Binary
1000
1001
1010
1011
1100
1101
1110
1111
3
1 1 0
13 12 11
EAR-Controlled Technology Subject to Restrictions Contained on the Cover Page.
2
0 1 0 1 1
10 9 8 7 6
May 2015
C F
0 0 1 1
5 4 3 2
Page 159
1 1
1 0