Diagnostic Simulation; Diagnostic Behavior - Endress+Hauser iTEMP TMT162 Operating Instructions Manual

iTEMP TMT162
Options
Factory setting

Diagnostic simulation

Navigation
Description
Display
User entry
Factory setting
Current output simulation →  89
Navigation
Value current output →  90
Navigation

Diagnostic behavior

Navigation
Description
Endress+Hauser
• No
• Yes
No
"Simulation" submenu
Expert → Diagnostics → Simulation → Diagnostic simulation
Use this function to switch diagnostics simulation on and off.
If simulation is active, the relevant diagnostic event is displayed with the configured status
signal. →  36
Off,
or a diagnostic event from the defined list of diagnostic events →  36
Off
Diagnostics → Simulation → Current output simulation
Expert → Diagnostics → Simulation → Current output simulation
Diagnostics → Simulation → Value current output
Expert → Diagnostics → Simulation → Value current output
"Diagnostic settings" submenu
Expert → Diagnostics → Diagnostic settings → Diagnostic behavior
A certain event behavior is assigned at the factory to each diagnostic event in the
categories: sensor, electronics, process and configuration. The user can change this
assignment for certain diagnostic events via the diagnostic settings. →  37
Operating menu and parameter description
115