Calibration Countdown - Endress+Hauser iTEMP TMT162 Operating Instructions Manual

Operating menu and parameter description

Calibration countdown

Navigation
Description
Lower range value→  72
Navigation
Upper range value →  72
Navigation
Failure mode→  77
Navigation
Failure current →  78
Navigation
Current trimming 4 mA →  78
Navigation
100
Expert → Sensor → Diagnostic settings → Calibration countdown
Use this function to view the time remaining until the next calibration.
Calibration countdown only runs when the device is active. Example: If the calibration
counter is set to 365 days on January 1, 2011 and no electricity is supplied to the
device for 100 days, the alarm for the calibration appears on April 10, 2012.
14.3.3 "Output" submenu
Setup → Lower range value
Expert → Output → Lower range value
Setup → Upper range value
Expert → Output → Upper range value
Setup → Advanced setup → Current output→ Failure mode
Expert → Output → Failure mode
Setup → Advanced setup → Current output→ Failure current
Expert → Output → Failure current
Setup → Advanced setup → Current output→ Current trimming 4 mA
Expert → Output → Current trimming 4 mA
iTEMP TMT162
Endress+Hauser