Display Interval; Value 1 Display (Value 2 Or 3 Display) - Endress+Hauser iTEMP TMT162 Operating Instructions Manual

iTEMP TMT162
Navigation
Description
User entry

Display interval

Navigation
Description
User entry
Factory setting

Value 1 display (Value 2 or 3 display)

Navigation
Description
User entry
Factory setting
Endress+Hauser
Setup → Advanced setup → Current output → Reset trim
Expert → Output → Reset trim
The Wizard resets the 4 to 20 mA values for trimming to the default value.
Activate the button
"Display" submenu
The settings for displaying the measured value on the optional display are made in the
"Display" menu.
These settings do not affect the output values of the transmitter, and are only used to
specify the display format on the screen.
Setup → Advanced setup → Display → Display interval
Expert → System → Display → Display interval
Use this function to set the length of time the measured values are displayed if the values
alternate on the display. This type of change is only generated automatically if several
measured values are specified.
The Value 1 display - Value 3 display parameters are used to specify which
measured values are shown on the local display →  79.
4 to 20 s
4 s
Setup → Advanced setup → Display → Value 1 display (Value 2 or 3 display)
Expert → System → Display → Value 1 display (Value 2 or 3 display)
Use this function to select one of the measured values to be shown on the local display.
• Process value
• Sensor 1
• Sensor 2
• Output current
• Percent of range
• Device temperature
Process value
Operating menu and parameter description
79