Installation
14
4.3
Display mounting
2
1
3 mm
4
4 display installation positions, attachable in 90° stages
1
Cover clamp
2
Housing cover with O-ring
3
Display with fitting kit and twist protection
4
Electronics module
1. Remove the cover clamp (1).
2. Unscrew the housing cover together with the O-ring (2).
3. Remove the display with twist protection (3) from the electronics module (4). Fit the
display with the fitting kit in the desired position in 90° stages and plug it into the
correct slot on the electronics module.
4. Then screw the housing cover together with the O-ring.
5. Fit the cover clamp (1) back on.
4.4
Post-installation check
After installing the device, always run the following final checks:
Device condition and specifications
Is the device undamaged (visual inspection)?
Do the ambient conditions match the device specification (e.g. ambient temperature,
measuring range, etc.)?
4
3
90°
90°
90°
90°
iTEMP TMT162
ON
Pro of-
OF F
Tes t
WR ITE
LOC K
A0025417
Notes
-
→ 46
Endress+Hauser