"Setup" Menu - Endress+Hauser iTEMP TMT162 Operating Instructions Manual

iTEMP TMT162
Device tag
Navigation
Description
User entry
Factory setting
Unit
Navigation
Description
Options
Factory setting
Sensor type n
Navigation
Description
Endress+Hauser
14.1

"Setup" menu

This menu contains all the parameters that are needed to configure the basic settings of
the device. The transmitter can be put into operation with this limited parameter set.
n = Stands for the number of sensor inputs (1 and 2)
Setup → Device tag
Diagnostics → Device information → Device tag
Expert → Diagnostics → Device information → Device tag
Use this function to enter a unique name for the measuring point so it can be identified
quickly within the plant. This name is shown on the display.
Max. 32 characters, such as letters, numbers or special characters (e.g. @, %, /)
32 x ' ? '
Setup → Unit
Expert → System → Unit
Use this function to select the engineering unit for all the measured values.
• °C
• °F
• K
• °R
• Ohms
• mV
°C
Setup → Sensor type n
Expert → Sensor → Sensor n → Sensor type n
Use this function to select the sensor type for the sensor input in question.
• Sensor type 1: settings for sensor input 1
• Sensor type 2: settings for sensor input 2
Please observe the terminal assignment when connecting the individual sensors. In
the case of 2-channel operation, the possible connection options must also be
observed.
Operating menu and parameter description
69