Table of Contents
Advertisement
Proline 500 PROFIBUS PA
8.3
Configuring the measuring device
The Setup menu with its submenus and guided wizards is used for fast commissioning of the
device. They contain all the parameters required for configuration, such as for measurement
or communication.
Depending on the device version, not all submenus and parameters are available in every
device. The selection can vary depending on the order code.
Example: Available submenus, wizards
System units
Analog inputs
Current input
Status input
Current output 1 to n
Pulse/frequency/switch output 1 to n
Relay output
User interface
Low flow cut off
Empty pipe detection
Advanced setup
8.4
Protecting settings from unauthorized access
The following write protection options exist in order to protect the configuration of the
measuring device from unintentional modification:
• Protect access to parameters via access code
• Protect access to local operation via key locking
• Protect access to measuring device via write protection switch
For detailed information on protecting the settings against unauthorized access, see the
Operating Instructions for the device.
9
Diagnostic information
Faults detected by the self-monitoring system of the measuring device are displayed as a
diagnostic message in alternation with the operational display. The message about remedial
Endress+Hauser
Meaning
Configure the units for all measured values
Configure the analog inputs
Configuration of the input/output type
Configure the display format on the local display
Set the low flow cut off
Configure empty pipe detection
Additional parameters for configuration:
• Sensor adjustment
• Totalizer
• User interface
• Electrode cleaning circuit
• WLAN settings
• Data backup
• Administration
Diagnostic information
45
Advertisement
Table of Contents
