Removing And Installing Trailing Arm With Mounting Bracket - Volkswagen Jetta 2005 Workshop Manual

– Drive dust cap on with fitting sleeve -3241/4- .
Note
Always renew removed grease caps.
♦
Damaged grease caps may allow moisture to enter the bear‐
♦
ing. Therefore, always use the tool shown in the illustration.
Continue installation in reverse order.
– Install wheel and tighten bolts or nuts
Specified torques
Component
Wheel hub with wheel bearing to wheel bearing housing
♦ Use new bolt
Brake disc to wheel bearing housing.
4.4 Removing and installing trailing arm with
mounting bracket
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1332-
♦ Support -T10149-
Removing
– Remove wheel.
– Remove coil spring
⇒ page 241
⇒ page 164 .
4. Assembly overview: wheel bearing housing, trailing arm (front-wheel drive)
Golf Variant 2007 ➤ , Jetta 2005 ➤
Running gear, axles, steering - Edition 07.2010
.
Specified torque
180 Nm + 180°
4 Nm
157