Assembly Overview: Drive Shaft With Vl90 Or Vl100 Constant Velocity Joint - Volkswagen Jetta 2005 Workshop Manual

Golf Variant 2007 ➤ , Jetta 2005 ➤
Running gear, axles, steering - Edition 07.2010
8 Assembly overview: drive shaft with VL90 or VL100 constant velocity
joint
1 - Outer constant velocity joint
❑ Renew only as com‐
plete unit
❑ Removing ⇒ page 94
❑ Installing: drive onto
shaft to stop using a
plastic mallet
❑ Checking ⇒ page 96
2 - Bolt
❑ M16 x 1.5 x 80
❑ Hexagon bolt, 200 Nm
and turn +180° further
❑ 12-point bolt, 70 Nm +
90° further
❑ Always renew after re‐
moving.
When bolt is loosened or tight‐
ened, vehicle must not be
standing on its wheels
3 - Right drive shaft
4 - Clamp
❑ Always renew after re‐
moving.
❑ Tightening ⇒ page 96
5 - Boot
❑ Check for splits and
chafing
❑ Material: Hytrel (poly‐
ester elastomer)
6 - Clamp
❑ Always renew after re‐
moving.
❑ Tightening ⇒ page 96
7 - Dished spring
❑ Installation position
8 - Thrust washer
❑ Installation position
9 - Retaining ring
❑ Always renew after removing.
❑ Insert in groove in shaft
10 - Boot for constant velocity joint
❑ Material: Hytrel (polyester elastomer)
❑ Without breather hole
❑ Check for splits and chafing
❑ Drive off constant velocity joint with a drift
❑ Coat sealing surface of constant velocity joint with -D 454 300 A2- before installing.
90
Rep. gr.40 - Front suspension
.
⇒ page 94 .
⇒ page 94 .