Removing And Installing Drive Shafts With Triple Roller Joint Aar3300I - Volkswagen Jetta 2005 Workshop Manual

– Bolt swivel joint to suspension link -arrows-.
Note
Ensure that bellows are not damaged or twisted.
– Tighten drive shaft bolt at wheel hub:
♦ Hexagon bolt ⇒ page 70
♦ Twelve-point bolt ⇒ page 71
Note
During this step, vehicle must not be standing on its wheels or
wheel bearing will be damaged.
– Install wheel and tighten bolts or nuts
Specified torques
Component
Swivel joint to cast steel suspension link
♦ Use new nuts
Swivel joint to sheet steel or forged aluminium suspension
link
♦ Use new nuts
Drive shaft to wheel hub „hexagon bolt"
♦ Use new bolt
Drive shaft to wheel hub „12-point bolt"
♦ Use new bolt
6.7 Removing and installing drive shafts
with triple roller joint AAR3300i
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1332-
Removing
– Loosen drive shaft bolt at wheel hub:
♦ Hexagon bolt ⇒ page 70
♦ Twelve-point bolt ⇒ page 71
Running gear, axles, steering - Edition 07.2010
⇒ page 241 .
Golf Variant 2007 ➤ , Jetta 2005 ➤
Specified torque
60 Nm
100 Nm
200 Nm + 180°
70 Nm + 90°
6. Removing and installing drive shafts
83