Assembly Overview: Drive Shaft With Triple Roller Joint Aar2600I - Volkswagen Jetta 2005 Workshop Manual

Golf Variant 2007 ➤ , Jetta 2005 ➤
Running gear, axles, steering - Edition 07.2010
11

Assembly overview: drive shaft with triple roller joint AAR2600i

1 - Outer constant velocity joint
❑ Renew only as com‐
plete unit
❑ Removing ⇒ page 103
❑ Installing: drive onto
shaft with plastic mallet
until compressed retain‐
ing ring seats.
❑ Checking ⇒ page 96
2 - Bolt
❑ M16 x 1.5 x 80
❑ Hexagon bolt, 200 Nm
and turn +180° further
❑ 12-point bolt, 70 Nm +
90° further
❑ Always renew after re‐
moving.
When bolt is loosened or tight‐
ened, vehicle must not be
standing on its wheels
3 - Right drive shaft
4 - Left drive shaft
5 - Clamp
❑ Always renew after re‐
moving.
6 - Boot for constant velocity
joint
❑ Check for splits and
chafing
❑ Material: Hytrel (poly‐
ester elastomer)
7 - Clamp
❑ Always renew after removing.
❑ Tightening ⇒ page 106
8 - Dished spring
❑ Installation position
9 - Thrust washer
❑ Installation position
10 - Retaining ring
❑ Always renew after removing.
❑ Insert in groove in shaft
11 - Clamp
❑ Always renew after removing.
❑ Tighten clamp with hose clip pliers -V.A.G 1275-
12 - Boot for triple roller joint
❑ Check for splits and chafing
114
Rep. gr.40 - Front suspension
.
⇒ page 117 .
⇒ page 117 .