– Evenly tighten bolts -arrows- for anti-roll bar clamp.
For the right side of the vehicle only (depending on equipment)
– Lower wheel suspension again using engine and gearbox jack
-V.A.G 1383 A- and remove support -T10149- from wheel hub.
– Remove tensioning strap -T10038- .
Continuation for both sides of vehicle:
– Connect coupling rod -2- to anti-roll bar and tighten nut -1-.
– Install wheel and tighten.
Specified torques
Component
Anti-roll bar to subframe
♦ Use new bolts
♦ Tighten threaded connections only when vehicle is in
the normal running position
Anti-roll bar to coupling rod
♦ Use new nut
⇒ page 241
Golf Variant 2007 ➤ , Jetta 2005 ➤
Running gear, axles, steering - Edition 07.2010
Specified torque
25 Nm + 45° further
13. Assembly overview: anti-roll bar (four-wheel drive)
45 Nm
227