Assembly Overview: Wheel Bearing Housing, Trailing Arm (Four-Wheel Drive) - Volkswagen Jetta 2005 Workshop Manual

Golf Variant 2007 ➤ , Jetta 2005 ➤
Running gear, axles, steering - Edition 07.2010
11 Assembly overview: wheel bearing housing, trailing arm (four-wheel
drive)
-Arrow- indicates direction of travel.
1 - Mounting bracket
2 - Cover
3 - Bolt
❑ M12 x 1.5 x 80
❑ 90 Nm + 90° further
❑ Always renew after re‐
moving.
4 - Coupling rod
❑ Connects anti-roll bar to
trailing arm and wheel
bearing housing
5 - Bolt
❑ 90 Nm + 45° further
❑ Observe tightening se‐
quence ⇒ page 207
❑ Always renew after re‐
moving.
6 - Trailing arm
❑ Removing and installing
⇒ page 211 .
❑ Repairing ⇒ page 215
7 - Drive shaft
❑ Assembly overview
⇒ page 228 .
❑ Removing and installing
⇒ page 230 .
8 - Multi-point socket head bolt
❑ M14 x 1.5 x 45
❑ 70 Nm + 90° further
❑ Always renew after re‐
moving.
9 - Wheel bearing housing
❑ Removing and installing
10 - Rear right speed sensor -G44- / rear left speed sensor -G46-
❑ Can be checked in guided fault finding of the vehicle diagnostic, testing and information system -VAS
5051-
❑ Before inserting sensor, clean inner surface of hole and coat with lubricating paste -G 000 650- .
11 - Hexagon socket head bolt
❑ M6 x 16
❑ 8 Nm
12 - Bonded rubber bush
❑ Renewing ⇒ page 208
13 - Nut
❑ M12 x 25
❑ 45 Nm
204
Rep. gr.42 - Rear suspension
⇒ page 205 .
.