Assembly Overview: Drive Shaft - Volkswagen Jetta 2005 Workshop Manual

Golf Variant 2007 ➤ , Jetta 2005 ➤
Running gear, axles, steering - Edition 07.2010
14

Assembly overview: drive shaft

1 - Outer constant velocity joint
❑ Renew only as com‐
plete unit
❑ Removing ⇒ page 234
❑ Installing: drive onto
shaft to stop using a
plastic mallet
2 - Bolt
❑ 70 Nm + 90° further
❑ Always renew after re‐
moving.
When bolt is loosened or tight‐
ened, vehicle must not be
standing on its wheels
3 - Drive shaft
❑ Allocation ⇒ Electronic
parts catalogue „ETKA"
4 - Clamp
❑ Always renew after re‐
moving.
❑ Tightening ⇒ page 236
5 - Boot
❑ Check for splits and
chafing
❑ Material: Hytrel (poly‐
ester elastomer)
6 - Clamp
❑ Always renew after re‐
moving.
❑ Tightening ⇒ page 236
7 - Dished spring
❑ With inner splines
❑ Installation position
8 - Retaining ring
❑ Always renew after removing.
❑ Insert in groove in shaft
9 - Boot for constant velocity joint
❑ Material: Hytrel (polyester elastomer)
❑ Without breather hole
❑ Check for splits and chafing
❑ Drive off constant velocity joint with a drift
❑ Coat sealing surface of constant velocity joint with -D 454 300 A2- before installing.
10 - Clamp
❑ Always renew after removing.
❑ Tightening ⇒ page 236
228
Rep. gr.42 - Rear suspension
.
⇒ page 235 .