Assembly Overview: Drive Shaft With Vl107 Constant Velocity Slip Joint (Push-On) - Volkswagen Jetta 2005 Workshop Manual

10 Assembly overview: drive shaft with VL107 constant velocity slip joint
(push-on)
1 - Outer constant velocity joint
❑ Renew only as com‐
plete unit
❑ Removing ⇒ page 110
❑ Installing: drive onto
shaft to stop using a
plastic mallet
❑ Checking ⇒ page 112
2 - Bolt
❑ 70 Nm + 90° further
❑ Always renew after re‐
moving.
When bolt is loosened or tight‐
ened, vehicle must not be
standing on its wheels
3 - Retaining ring
❑ Always renew after re‐
moving.
❑ Insert in groove in shaft
4 - Thrust washer
❑ Installation position
⇒ page 111 .
5 - Dished spring
❑ Installation position
⇒ page 111 .
6 - Clamp
❑ Always renew after re‐
moving.
❑ Tightening ⇒ page 112
7 - Boot
❑ Check for splits and
chafing
❑ Material: Hytrel (polyester elastomer)
8 - Clamp
❑ Always renew after removing.
❑ Tightening ⇒ page 112
9 - Drive shaft
10 - Clamp
❑ Always renew after removing.
❑ Tightening ⇒ page 112
11 - Boot for constant velocity slip joint
❑ Material: Hytrel (polyester elastomer)
❑ Without breather hole
❑ Check for splits and chafing
12 - Retaining ring
❑ Always renew after removing.
.

10. Assembly overview: drive shaft with VL107 constant velocity slip joint (push-on)

Golf Variant 2007 ➤ , Jetta 2005 ➤
Running gear, axles, steering - Edition 07.2010
109