Removing And Installing Drive Shafts With Triple Roller Joint Aar2600I - Volkswagen Jetta 2005 Workshop Manual

Component
Swivel joint to sheet steel or forged aluminium suspension
link
♦ Use new nuts
Drive shaft to wheel hub „12-point bolt"
♦ Use new bolt
6.6 Removing and installing drive shafts
with triple roller joint AAR2600i
Special tools and workshop equipment required
♦ Torque wrench -V.A.G 1332-
♦ Wedge -T10161-
Removing
– Loosen drive shaft bolt at wheel hub:
♦ Hexagon bolt ⇒ page 70
♦ Twelve-point bolt ⇒ page 71
Note
During this step, vehicle must not be standing on its wheels or
wheel bearing will be damaged.
– Remove wheel.
– Remove lower noise insulation ⇒ General body repairs, ex‐
terior; Rep. gr. 50 ; Assembly overview - noise insulation .
Golf Variant 2007 ➤ , Jetta 2005 ➤
Running gear, axles, steering - Edition 07.2010
Specified torque
70 Nm + 90° further
6. Removing and installing drive shafts
100 Nm
81