Assembly Overview: Wheel Bearing Housing, Trailing Arm (Front-Wheel Drive) - Volkswagen Jetta 2005 Workshop Manual

4 Assembly overview: wheel bearing housing, trailing arm (front-wheel
drive)
1 - Bolt
❑ 50 Nm + 45° further
❑ Always renew after re‐
moving.
2 - Mounting bracket
3 - Bolt
❑ M12 x 1.5 x 80
❑ 90 Nm + 90° further
❑ Always renew after re‐
moving.
4 - Coupling rod
❑ Connects anti-roll bar to
trailing arm and wheel
bearing housing
5 - Bolt
❑ Observe tightening se‐
quence ⇒ page 159
❑ 90 Nm + 90° further
❑ Always renew after re‐
moving.
6 - Trailing arm
❑ Removing and installing
⇒ page 157 .
❑ Repairing ⇒ page 161
7 - Bolt
❑ 8 Nm
8 - Rear right speed sensor -
G44- / rear left speed sensor -
G46-
❑ Can be tested in guided
fault finding using ⇒ Ve‐
hicle diagnostic, testing and information system VAS 5051
❑ Before inserting sensor, clean inner surface of hole and coat with lubricating paste -G 000 650- .
9 - Wheel bearing housing
❑ Removing and installing
10 - Bonded rubber bush
❑ Renewing ⇒ page 152
11 - Nut
❑ 45 Nm
❑ Always renew after removing.
12 - Bolt
❑ 4 Nm
13 - Brake disc
14 - Dust cap
❑ Always renew after removing.
❑ Pressing off and driving in
.
⇒ page 148 .
.
⇒ page 155

4. Assembly overview: wheel bearing housing, trailing arm (front-wheel drive)

Golf Variant 2007 ➤ , Jetta 2005 ➤
Running gear, axles, steering - Edition 07.2010
147