Note Regarding The Display Of Worker Details At The Acw - Thermo Scientific DCS4 Manual

Using the ACW for Loading Tasks into the EPD
Note regarding the display
of Worker details at the
ACW
Selecting the Load Tasks
Process
EPD Prompt
9-2 A Guide to Using DCS4 Access Control Workstation
If Display Forename1 instead of Initials at ACW is ticked on
the System Configuration tab of the System Setup screen, the
Worker's name will be displayed as follows:
If Display Forename1 instead of Initials at ACW is NOT ticked
on the System Configuration tab of the System Setup screen,
the Worker's name will be displayed as follows:
Throughout this manual, the Initials option has been set.
See A Guide to Using DCS4 Data Management and Reporting
Ref No. EPD/MHB/61066/000 for further information.
Select the Load Tasks from the menu using the Up/Down
buttons and 'ENT'.
When the ACW is available for Loading Tasks, a message
(similar to the one below) is displayed on the screen:
The Load Tasks Process is initiated by inserting an EPD into
the ACW.
Issue: 1.78
Thermo Fisher Scientific