Selecting The Entry Process - Thermo Scientific DCS4 Manual

Issue: 1.78
Selecting the Entry
Process
EPD Prompt
Read EPD Error Messages
Thermo Fisher Scientific
Select the Entry Process from the menu using the Up/Down
buttons and 'ENT'.
Note: If the ACW has been setup for Auto Entry/Exit process,
the EPD Prompt window is displayed (see
4-3)). The system checks whether the EPD has been issued or
not as follows:
1. If the EPD is issued, the system assumes that the EPD needs
to be returned and commences the Exit Process (see
Exit Process (page 5-2)).
2. If the EPD is not issued, the system assumes that the EPD
needs to be issued and commences the Entry Process (see
RCA Entry Process (page
When the ACW is available for RCA Entry, a message (similar
to the one below) is displayed on the screen:
The Entry Process is initiated by inserting an EPD into the
ACW.
If the EPD cannot be read, an error message is displayed:
Using the ACW for RCA Entry
EPD Prompt (page
4-1)).
A Guide to Using DCS4 Access Control Workstation
The RCA
The
4-3