Thermo Scientific DCS4 Manual page 41

Issue: 1.78
The System Administrator
sets the Hide PIN in the
Configuration program
(see A Guide to Using
DCS4 ACW Manager Ref
No.
EPD/MHB/61064/000).
For details regarding
the System Setup, see
A Guide to Using
DCS4 Data
Management and
Reporting Ref No.
EPD/MHB/61066/000
Thermo Fisher Scientific
Note that the picture above does not show the Worker's PIN as
the Hide PIN is selected. If the Hide PIN is not selected, the
Worker's PIN is displayed as follows:
When the EPD has been successfully issued, the following
Issue message is displayed indicating that the user may
proceed:
Note that if the Show Alarm Settings on Issue is enabled in the
System Setup, the Dose Alarm and Rate Alarm for the selected
Task shall be displayed as follows:
Note: If an Audio Card is fitted to the ACW then an audible
message of confirmation will also be given:
See A Guide to Using DCS4 ACW Manager Ref No.
EPD/MHB/61064/000 for further information about setting up
the audio messages.
Using the ACW for RCA Entry
A Guide to Using DCS4 Access Control Workstation 4-17