Issue: 1.78
Chapter 4
Thermo Fisher Scientific
Using the ACW for RCA Entry
Introduction to the RCA Entry Process
The RCA Entry Process provides an automated system for
monitoring a Worker's entry into the RCA. The process will
verify the workers entry details and radiological history before
a Task Number is entered.
The System Administrator has the ability to configure the
ACW for Entry, Exit or Transfer Process (or a combination of
them). An ACW that has been configured for the Entry Process
is setup so that a worker must identify themselves and then
insert a Task ID.
The System Administrator is also able to configure the ACWs
or individually to suit different environments and requirements
e.g.:
Select different Processes
Hide PIN (which masks the Worker's ID with asterisks)
Require ID on Exit (which ensures that the Worker
enters their PIN during the Exit Process)
Display Dose on Issue
Worker Prompt Type
Task Prompt Type
Note: See A Guide to Using DCS4 ACW Manager Ref No.
EPD/MHB/61064/000 and A Guide to Using DCS4 System
Administrator Ref No. EPD/MHB/61065/000 for further
information
If an error occurs or an Entry fails the ACW will display an
error message.
The RCA Entry Process
The Entry Process involves the following steps:
1. Selecting the Entry Process from the main ACW menu -
see
Selecting the Entry Process (page
2. Inserting the EPD into the Reader – see
(page
4-3).
Using the ACW for RCA Entry
4-3).
EPD Prompt
A Guide to Using DCS4 Access Control Workstation
4-1