Chapter 8 Using The Acw For Changing Pin - Thermo Scientific DCS4 Manual

Issue: 1.78
Chapter 8
Note regarding the display
of Worker details at the
ACW
Thermo Fisher Scientific
Using the ACW for Changing PIN
Introduction to the RCA Change PIN
Process
Selection of Change PIN process does not provide access to the
Radiologically Controlled Area, but it allows workers to reset
their Personal Identification Number (PIN).
The Change PIN Process
The Change PIN Process involves the following steps:
1. Selecting the Change PIN Process from the main ACW
menu – see Selecting the Change PIN Process (page 8-
2).
2. Entering the Worker Details – see
Worker
(page 8-2).
4. Entering Current PIN details – see
(page 8-3).
5. Entering New PIN details – see
(page 8-3).
If Display Forename1 instead of Initials at ACW is ticked on
the System Configuration tab of the System Setup screen, the
Worker's name will be displayed as follows:
If Display Forename1 instead of Initials at ACW is NOT ticked
on the System Configuration tab of the System Setup screen,
the Worker's name will be displayed as follows:
Throughout this manual, the Initials option has been set.
See A Guide to Using DCS4 Data Management and Reporting
Ref No. EPD/MHB/61066/000 for further information.
Using the ACW for Changing PIN
Identifying the
Entering Current PIN
Entering New PIN
A Guide to Using DCS4 Access Control Workstation 8-1