Notes Regarding Error Messages During The Transfer Process - Thermo Scientific DCS4 Manual

Using the ACW for Task Transfer
For details regarding
the System Setup, see
A Guide to Using
DCS4 Data
Management and
Reporting Ref No.
EPD/MHB/61066/000
Notes regarding Error
Messages during the
Transfer Process
6-12 A Guide to Using DCS4 Access Control Workstation
Note that if the Show Alarm Settings on Issue is enabled in the
System Setup, the Exit Alarm and Peak Dose for the exit Task
shall be displayed and the Dose Alarm and Rate Alarm for the
entry Task shall be displayed as follows:
If an Audio Card is fitted to the ACW then an audible message
of confirmation will also be given:
See A Guide to Using DCS4 ACW Manager Ref No.
EPD/MHB/61064/000 for further information about setting up
the audio messages.
During the Transfer the ACW will perform checks on worker
authorization, Task ID validity, workers Dose Margins as well
as other system and EPD checks.
If any of these checks are not satisfied then the Transfer will be
denied and the worker will be notified why, via an error
message.
The error message consists of an Error Code Number and some
descriptive text. The System Administrator may change the
text, but the error Code Number will be the same (see A Guide
to Using DCS4 System Administrator Ref No.
EPD/MHB/61065/000 for further information).
To assist the Health Physicist in identifying the problem, make
a note of the Error Number (in brackets).
Issue: 1.78
Thermo Fisher Scientific